After a Hard-Reset your radio again is in the Mode of the Jumper-SET. Your modify is aviable till the next hard-reset of your radio. You can switch to Wide RX, Wide RX+TX, you can enter manual values and of course recover the original value.
Both works ok, without anyįor Modify the FT897-Radio do not change the jumpers, do this with this software - it is the simplest way and very save for your radio. Original adapter and here a simple adapter-version. , certainly you can use a selfmade adapter. The adapter is aviable in all Radio-shops / HAM-shops.
My Software in this version assumes the COM-Port 1-8 on your PC / Laptop. This results in the following command screen with limited buttons and no sliders.I have finished this project, no support ! !įor a connect switch the radio to 4800 Bd in MENU-SET #19 and CAT-MODE in MENU-SET #20. See the operating manuals for further information. The only functions we can run are the ones that are in the FT-817, FT-847, FT-857, FT897 control set. You are free to discuss this with Chris Wilson at Yaesu USA. We strongly advise that you do not run any version prior to 6.3.0.410 otherwise you are risking destruction of the memory device this will stop your radio from functioning. We would be negligent if we failed to take this action. We have taken this action to prevent damage to user’s radios. So we have had to remove this kludge code and can only use the official CAT commands now. We HAD to do this as the V5 and previous developers had added some of their own code that wrote directly to the flash ram on the rig, this has been causing the flash ram chips to fail, and Yaesu can no longer get replacement chips. Yaesu USA have advised us to remove some of the controls from the FT-817, FT-847, FT-857, FT897 which were not directly supported by the firmware CAT command set. Ham Radio Deluxe V6.3.0.410 or later builds.
Solution home Knowledgebase Radio Support Yaesu FT-8X7 Cat Cmd Removal
0 kommentar(er)
